SD Card Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
While I'm waiting for a print to complete I usually load up a few models on SD Cards and stick them near the printer,…
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 169
- Wydruki
- 2
- Wyświetlenia
- 920
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
While I'm waiting for a print to complete I usually load up a few models on SD Cards and stick them near the printer, when the print finishes I pull the old card and put the new in. Sometimes I forget to take the old one away and end up with it in the pile of 'next' cards. I don't mark my SD cards or name the files on them so I end up clearing the cards and starting again or just guessing.
I designed this to hold 5 SD cards on my IKEA lack enclosure. This means I can queue my spontaneous prints and have some form of order.
I mark the enclosure door with the SD card contents (Lack marker holder here https://www.prusaprinters.org/prints/32754-lack-table-dry-wipe-marker-holder)
When a print is complete I wipe it off (Lack eraser here https://www.prusaprinters.org/prints/32753-lacktable-whiteboard-eraser-holster)
Print instructions
I was afraid that this would sag and the cards would not fit, so I printed it in the orientation it would be used. This worked out well and I had no issues with my prints.
I don't think the infill is important here, I used 15%
I printed in PETG with a 0.2mm layer height
I used a Prusa i3 Mk3s with the textured steel sheet
No Skirt or brim necessary
No supports necessary