BIGTREETECH HDMI7 screen case and mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case and a mount for BTT HDMI7 screen. The screen can be conveniently mounted or used in a portable way when needed.
- Ocena
- 0 / 5
- Polubienia
- 36
- Pobrania
- 406
- Wydruki
- 0
- Wyświetlenia
- 3706
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
No hardware is needed apart from the 4 OEM screws.
Case
The case has cutouts for all the screen's ports and buttons. It mounts on the screen with the 4 OEM screws.
I also created a bezel to compensate for the thin gap on the bottom of the case. The gap was a necessary design feature to give room for the screen's internal cables.
To install the bezel, first put one side in the middle of the case's gap, slide it and then clip it in.
Printing
- 40% infill
- No supports needed
- 0.2mm resolution
Mount
Requirement: The above case must first be installed on the screen for it to be mounted.
The mount is designed so that the screen is facing in a comfortable position (45°) and can slide on and off the mount from the top. This allows for removing the screen when needed. Also, it has a cutout for all the screen's ports and the buttons can be accessed from the top.
The mount does not need any hardware to be installed, as it fits the aluminum extrusion of the printer.
Instructions
- Print the 2 separate parts: BTT HDMI7 screen mount half 1 and BTT HDMI7 screen mount half 2.
- Slide the 2 printed parts one after the other to the aluminum extrusion making sure that the part with the rectangular cutout (for the cables) is on the right-hand side and that the mount is facing upwards.
- Apply super glue between the two parts and press them together tightly for several seconds, then leave them intact until the glue dries completely.
- Slide the screen on the mount and enjoy printing!
Printing
- 20% infill
- No supports needed
- 0.2mm resolution
Note: The amount of tolerance for the extrusion mount points is such that the mount fits perfectly to the frame of the printer, without moving around. This means that for installing it for the first time, some amount of force may be required.