1 / 12
Quick swap adjustable monitor stand for 75mm vesa
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made a holder/arm for my wacom cintiq 16.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 1001
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (14)Powiązane
I made a holder/arm for my wacom cintiq 16.
as this is going to hold a expensive screen and even have the presure of the screen being used at the same time i tried making it as robust as possible, and i figured that the feet would be nice if they were of metal so i use 2x 24cm 8mm chrome rods as the feet.
in order to build this you will need
2x 240mmx8mm rods
6x m5 bolts and nuts
6mm spacers if needed
24x m3 bolts and nuts
2x springs that can go on the opposite side of the adjustment plate so that you only need to push on the bolt to release the lock