1 / 2
Garage for toy car - one piece print (+ door) — zdjęcie 1
1 / 2

Garage for toy car - one piece print (+ door)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Putting together main part and roof was not pretty, so i changed project to be printed as one piece (two with doors).

Ocena
5 / 5
Polubienia
98
Pobrania
752
Wydruki
3
Wyświetlenia
2946
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Public Domain

Putting together main part and roof was not pretty, so i changed project to be printed as one piece (two with doors). 

I putted a hole in the corner of an entrance to the garage, to make it possible to put the door inside. It needs a little bit of force and maneuvering to get them there, but afterwards it stays in place and don't fell out. 

The roof is sitting on walls low enough to prevent doors from sliding back to the very end of the garage (because the knob is not able to fit under the roof).

Additionally i made shorter version of the garage, which is enough for smaller cars (like hot wheels).

I printed it with PET-G.

Tagi