Ikea LedBerg clip for Vertex K8400
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ikea Ledberg mount loosely based on the old, discontinued Dioder mount.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 116
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
As I found out the Ikea Dioder series was discontinued and I still wanted to put LED-strips in my 2nd Vertex K8400 I bought the replacement series "Ledberg" LED-strips. These need a slightly bigger clips than the Dioder series did so I remixed H60's design to fit the "Ledberg" series. Also, the "new" 2017 series has only 6 LED's per strip, these are a bit brighter than the Dioder LED's btw as can be seen the picture.
A couple of drawbacks of the Ledberg series are:
- There are only 3 strips in a package, but, the adapter allows for the connection of 4 strips. The adapter can supply 3 watts and the light strips use 6 x 0.06 watts = 0.36 Watts, so 4 strips only use 1.44 Watts, well within the limit. I observed no temperature change in the adapter running 4 strips.
- These LED-strips do not include the short wires to connect the strips around corners. I choose to solder wires directly to the strips, though a bit of extra work this works fine! Using a wire of 5 cm or 2 inches for the Metric impaired will do nicely.
Print Settings
Printer:
Vertex K8400
Rafts:
No
Supports:
No
Resolution:
0.2 mm layers
Infill:
25%
Category: 3D Printer Parts