Edelbrock 1806/1906 Duct Intake
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A printable air intake duct with filter system. Filter part can be cut from a special filtration "cloth"
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 361
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
One of the first things I wanted to upgraded on my Chevrolet Monte Carlo '76. Was the intake filter system, as well as using my 3D printer for a car project.
So I came up with this design, not optimal in terms of it sucking the hot engine bay air in and through the engine, But a good first project and mechanical and thermal test of 3d printed parts.
The filter part consists of a 5mm thick alu plate and above it goes a hand cut filter material of your own choosing. I had an abundance of fine meshed plastic sheet filter material at my work, so I choosed that.
Similar to this;
https://duckduckgo.com/?q=filter+material+mesh&atb=v316-1&iax=images&ia=images
The filament material to be used should be either of these materials, to prevent melting of the 3d printed parts;
Polycarbonate
CARBONX™ PC+CF
CARBONX™ PA6+CF
PAHT CF15
Or similar filaments, not PLA, PETG or ABS. They will melt eventually!
If you encounter a problem, leave a comment down below.