1 / 22
SK-Cube toolhead LGX lite Rapido single 5015 Partcooling
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
an easier smaller and fully functional Toolhead with individual Fanshroud should it slope down
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 244
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
New version is easier to assemble and a bit more plastic to remove the creep issue I faced after about 100 hours of printing.
Install:
0. Install heat inserts if used into towers.
- install 2 nuts into holes for the sideways30x30 fan
- install sensor holder at the bottom with M3x8 screws from top and nuts on back, 8mm Hole should be aligned with the holes up front (Offset X0 Y24.5)
- Install Rapido Hotend with the screws used for the V6 adapter (M2.5 6mm?)
- Cut PTFE Tube to 23mm and install in Rapido from top
- Put LGX Lite into place above rapido and push original screws through holes to install motor (will be done later in SK-Cube)
- install 30x30 fan with 2 M3x12mm screws on side of Rapido (make sure airflow will face rapido)
Now inside Printer
- Install Sensor in mount, try to have it ~1mm higher then nozzle
- add Motor to back of plate and install with 2 screws of LGX Lite
- put Fanshroud over 5015 and install with 2 M3x20mm screws into tower
- Install Plate to CF Plate with 4 Nuts and 4 Washers (like previous CF Plate)