1 / 22
SK-Cube toolhead LGX lite Rapido single 5015 Partcooling
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
an easier smaller and fully functional Toolhead with individual Fanshroud should it slope down
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 11
- Makes
- 0
- Views
- 244
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
New version is easier to assemble and a bit more plastic to remove the creep issue I faced after about 100 hours of printing.
Install:
0. Install heat inserts if used into towers.
- install 2 nuts into holes for the sideways30x30 fan
- install sensor holder at the bottom with M3x8 screws from top and nuts on back, 8mm Hole should be aligned with the holes up front (Offset X0 Y24.5)
- Install Rapido Hotend with the screws used for the V6 adapter (M2.5 6mm?)
- Cut PTFE Tube to 23mm and install in Rapido from top
- Put LGX Lite into place above rapido and push original screws through holes to install motor (will be done later in SK-Cube)
- install 30x30 fan with 2 M3x12mm screws on side of Rapido (make sure airflow will face rapido)
Now inside Printer
- Install Sensor in mount, try to have it ~1mm higher then nozzle
- add Motor to back of plate and install with 2 screws of LGX Lite
- put Fanshroud over 5015 and install with 2 M3x20mm screws into tower
- Install Plate to CF Plate with 4 Nuts and 4 Washers (like previous CF Plate)