CR10S Pro Ribbon Cable Breakout Board Mount for 2020 Extrusion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CR10S Pro Ribbon Cable Breakout Board by Darknode Mount for 2020 Extrusion
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 737
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple quick mount to have the breakout board mounted on the 2020 extrusion beneath the printer. I designed my own mount for my SKR 3 board that rotates the SKR3 board 90 degrees in comparison to the factory board. Unfortunately this doesn't leave much room to keep the breakout board attached. I decided to mount the breakout board to the 2020 instead.
The reason I mounted my board 90 degrees is to allow more space for a second power supply to run the motors, fans, hotend, led's, etc. Some have issues with skipped steps when the heater is pulling full power. I personally haven't, but figured I'd add the second power supply I had laying around and just keep the original for only the heated bed.
Note: Model is in inches, so you may have to scale up to millimeters if your slicer doesn't automatically do it. Prusaslicer does this for you.