1 / 8
Forced Air Deflector for Tukkari Prusa Enclosure — zdjęcie 1
1 / 8

Forced Air Deflector for Tukkari Prusa Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Made to improve forced airflow to power supply unit after I added a 2 inch tall concrete slab into enclosure.

Ocena
0 / 5
Polubienia
3
Pobrania
15
Wydruki
0
Wyświetlenia
402
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

After adding a 2" tall concrete block to reduce vibration while printing (which works great BTW), my printer sat higher than before. Due to this, the power supply unit (PSU) was above the cut out of my Tukkari enclosure, and some cool air from my fan was getting towards the bed. This also was not optimal cooling for PSU.

So, I created this part with a 60 degree angle to redirect any air with the potential to escape into the bottom of the PSU. I immediately noticed a difference in the temp sensor I have attached to the PSU.

The forced air from my larger fan moved the part a bit, so I added some double-sided tape to the bottom and after that it was good to go!

Tagi