1 / 8
Rancilio Silvia V6 Nextion display enclosure for Gaggiuino — zdjęcie 1
1 / 8

Rancilio Silvia V6 Nextion display enclosure for Gaggiuino

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Gaggiuino enclosure for Nextion 2.4 inch display. Fits the front panel of Rancilio Silvia V6.

Ocena
0 / 5
Polubienia
39
Pobrania
209
Wydruki
0
Wyświetlenia
5006
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Nextion 2.4 inch display enclosure that fits the front panel of Rancilio Silvia V6. Intended to be used as part of a Gaggiuino install.

The design leverages the V6 power and boiler indicator lights to route the wires to the screen. It replaces the front face for the two lights with a shorter version that leaves enough clearance to anchor the screen enclosure and route up to 8 26 AWG silicone wires.

The enclosure has a cut out for micro SD card to flash Nextion firmware, and a fixture and cutout for an USB-C breakout board. The breakout board was intended to be wired to an ST-LINK adaptor to allow flashing the STM32 blackpill MCU. I use it wired to the female side of a USB A extension cable.

To assemble, use 6 M2x5 self-tapping countersunk screws.

To attach to the machine, I used 4 10x3 mm magnets in the back of the lid (most 10mm diameter should fit).

Alternatively, there’s a cutout at the back to use about an inch of 1” width mounting tape (for example, this one).

Tagi