1 / 8
Rancilio Silvia V6 Nextion display enclosure for Gaggiuino — image 1
1 / 8

Rancilio Silvia V6 Nextion display enclosure for Gaggiuino

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Gaggiuino enclosure for Nextion 2.4 inch display. Fits the front panel of Rancilio Silvia V6.

Rating
0 / 5
Likes
39
Downloads
209
Makes
0
Views
5,006
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

Nextion 2.4 inch display enclosure that fits the front panel of Rancilio Silvia V6. Intended to be used as part of a Gaggiuino install.

The design leverages the V6 power and boiler indicator lights to route the wires to the screen. It replaces the front face for the two lights with a shorter version that leaves enough clearance to anchor the screen enclosure and route up to 8 26 AWG silicone wires.

The enclosure has a cut out for micro SD card to flash Nextion firmware, and a fixture and cutout for an USB-C breakout board. The breakout board was intended to be wired to an ST-LINK adaptor to allow flashing the STM32 blackpill MCU. I use it wired to the female side of a USB A extension cable.

To assemble, use 6 M2x5 self-tapping countersunk screws.

To attach to the machine, I used 4 10x3 mm magnets in the back of the lid (most 10mm diameter should fit).

Alternatively, there’s a cutout at the back to use about an inch of 1” width mounting tape (for example, this one).

Tags