4040 Cinderblock-Style Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Slides right on your 4040 rail for additional 50mm height!
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 397
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Upgraded V2 - Locks On TIGHT!
Some feet to slide on you 4040 Rail to add some lift!
No issues with vibes (printing speeds up to 120mm/s & 800mm/s Acceleration tested on a Sovol SV04).
Added Self-Adhesive furniture pads to the bottom for grip
Height added is 50mm (57 Total)
2 Widths for easy printing, OR you can scale up/down your Z in your slicer to any width
Print in PLA or PETG. Just be aware that PLA has a lower melting temp.
Currently using PLA ones with zero issues but I don’t print over 260.
Printed in Polyterra Matte Black PLA @ 202/60 .6 Nozzle .28LH / .8LW
3 Walls
4 Top/Bottom - Concentric
Cubic infill 40-60%
Print on side - No Supports or Brim should be needed
For the SV04 - 2 x 40mm - Front - 2 x 30mm - Rear
No need to remove stock feet!
Fit should be tight on V2!
I GENTLY tapped them on w a rubber Mallet :)
Enjoy and please post your makes!