Experimental Bridging Hot Air Balloon (1,100 bridges)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Brims recommended. Use "Classic" Perimeters for gcode, works better.
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 88
- Wydruki
- 2
- Wyświetlenia
- 675
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Share Alike
USE BRIMS - SLOW DOWN AS YOU GO HIGHER - MAY POP OFF PRINT BED
Based on earlier learning with Air Trees https://www.printables.com/model/340401-air-trees-easy I wanted to see what was possible at the upper end of the technique.
Recently I went for my first hot air balloon ride and it inspired me to create this shape.
This model has 1,100 bridges & an internal girder frame. It's designed specifically for .20mm layers.
Scaling: If you scale to 75% and change layers to .15mm it might work. Same with 50% scale and .10 layers although I'm not sure that will work.
I was at 90% and I tried to add some support and popped it loose myself.
===========================================
Too much? Try Air Trees! (Below)
https://www.printables.com/model/340401-air-trees-easy