BASE STAND MOUNT M6 FOR LIGHTING OR CAMERA
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
BASE STAND FOR ONE SCREW MOUNTING
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 220
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
When used for M6 nut/screw native scale is made for 300x300 printbed (around 240x240 diagonally)
For M5 nut/screw and entry level printbed size scale down 0.8x (or 80% of original model)
Minimum or none support necessary as usual, skirt improves printbed adhesion, on 0.8 or thicker nozzle diameter one wall pass is just fine
Circular part that is sticking out the top is supposed to fit the hole of the part that is to be mounted. It is around 11mm in diameter, for 12mm hole.
The groove is for optional oring 20x2.5 that makes spinning harder
Made this for my lamp, check my other models for different iterations (M8)
Toggle nut/screw holders M6 model:
https://www.printables.com/model/228507-wheel-screw-holder-60mm-for-m6-hex-screw-bolt-nut
Toggle nut/screw holders M6 model viral:
https://www.printables.com/model/228503-viral-wheel-screw-holder-toggle-for-m6-hex-screw-b
SHARE LIKE COMMENT TIP - POST A MAKE
My other designs
https://www.thingiverse.com/thesloppyapprentice/designs
https://www.printables.com/social/296116-the-sloppy-apprentice/models
Take a look at my youtube channel:
https://www.youtube.com/channel/UCqKU0euRjGItYjY0grGPFjw