1 / 4
Ambiano Food Dehydrator Filament Drying Adapter Ring - Cardboard version
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I did not want to wait 10h of print time and use 400g of filament just for a test. So I came up with this idea.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 754
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The original model inspired me to do this cardboard mod. I just wanted to test if drying ASA is possible with a dehydrator (yes it is possible 6h @70°C) so I created this cardboard ring.
Model files: The attached STL is just a cube as a dummy because you can only publish a model with a 3D file attached.
Bill of material:
- 1-2 pieces of cardboard fitting in the slots on the side
- Small left over of cardboard
- Masking tape
- Dryer rack (middle piece recommended so you can still sue the dryer for something else)
- 10-15min of time
How to install:
- Cut the card board to size
- Length according to your dryer, with 30-50 mm overlap
- Height according to your spool thickness
- Roll cardboard around a thin cylinder to preform it, e.g. with a rolling pin.
- Insert the 1-2 rolled cardboard pieces in to the dryer rack slots.
- Fixate the pieces with some masking tape
- Now seal the joint between the cardboard and dryer rack with masking tape
- Seal the middle hole of the dryer rack to distribute the air to the sides.
- Make some spaces from masking tape and cardboard left overs.
- Put spool in close the lid and dry the filament.