Skadis Wireless Phone Charger vers. 2.0

This wireless charger housing remixes my favourite Skadis phone holder to allow it to charge your phone while you work!

The shape of Beyond_Life's Phone Holder Hook was perfect to allow you to just pop your phone onto it, set it and forget it.

This one's for all of you who work from home and find having charging cables by your bedside to be annoying, you'll never need to charge while you sleep again.

I will say, this is version 2.0. There will most likely be a version 2.1 coming in Q1 2023.

Print Settings

Printer Brand:

Prusa

Printer: 

Prusa Mk2

Rafts:

No

Supports: 

Yes

Resolution:

0.1 mm

Infill: 

15%

Filament: EconoFil Generic PLA Translucent

Notes:

Printed on a Prusa Mini, some imperfections remain for vers. 3 - but this one works a treat so I thought I'd upload it.

I recommend translucent filament as it translates the colours of the charger very effectively, but since the coverplate is a separate object, as long as you don't increase its depth you should be fine to customize it with multiple colours or a particular design.

Snugly designed to fit M2x8 screws and nuts - individual printer results may require minor alteration.

Post-Printing

This is the charger geometry designed for, available on a few internet marketplaces including the big one that shan't be named.

Cable Management

I recommend purchasing a reasonably robust USB-C to USB-C ribbon cable to run through the hole in your pegboards, as typical USB-C cables are a little too chunky at the connector. Run a normal cable up the back of your Skadis, then plug into the ribbon cable for the last few centimeters.

How I Designed This

Design

Designed in Rhino 7, reach out to me if you would like NURBS files.