Showerhead Extension Mount

[24/06/2019] Update: the pin that holds the showerhead, broke off on my print. To fix this problem, I drilled a 4mm hole through the pin and the mount, after which I inserted an M4 bolt for strength. If you are concerned about the strength of this part, you can print the reinforced .STL file, which includes a 4mm hole for an M4 bolt to be inserted into. I am in no way responsible if you end up in ER with a concussion ;)

I modelled this showerhead extender, because my showerhead was too close to the wall. The part is printed with 100% infill for high strength and has been designed in such a way that you don't need support material. If you want to bottom side of this extender to be a bit cleaner though, you could turn support on.

Support

If you'd like to support me for the 3D models I distribute for free, you can use my AliExpress affiliate link: https://s.click.aliexpress.com/e/_oFT8Gq6

Whenever you buy something through this link, I get a small kickback without costs for you ;)

Thanks for your support!

Print Settings

Printer Brand: Anycubic

Printer: All-metal Mega

Rafts: No

Supports: Doesn't Matter

Resolution: 0.2mm

Infill: 100%

Filament: ColorFabb PLA/PHA Blue Gray