Watch opening tool 40mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It is used for opening the watches back cover, in order to replace the battery
- Ocena
- 5 / 5
- Polubienia
- 58
- Pobrania
- 615
- Wydruki
- 3
- Wyświetlenia
- 2041
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
This opener should fit on all common 40mm watches with a threaded back plate. Some higher end watches need a specified torque value applied for closing, to be waterproof again afterwards. There fore this tool features a 3/8'' drive in the middle to fit your torque wrench.
Note: The notches have a 2mm size and fit verry tight. If you tend to over extrude, you might tune slightly towards underextrusion to make them fit better.
For layers a 0.1 hight worked fine for me.
CHANGE LOG 23.07.2023:
Added a version with longer handle bars to give you more grip. The long handle version has the normal 2mm sized notches
CHANGE LOG 27.01.2023:
Added a version with “smaler” notches. Theyr size is reduced from 2mm to 1.75mm widht. Therefore they should fit much better even with slight over extrusion