Steering Wheel and shifter holder add on for Skillster simulators + Joystick replacement parts

These are add on parts to give our Skillster simulators a little bit more realistic car feeling (for a low cost) when you drive different vehicles, especially the manually shifted car and Truck (Lorry). Although all vehicles benefit from a larger steering wheel. 

It fits the Logitech G920/G923

Print parts oriented as shown i pictures above. I used 0,35 layer hight and 15% cubic infill on 0.6 nozzle on a Prusa MK3S. No supports needed.

The wheel is built with four printed parts that is joined together with Dove Tail joints. A bit of super glue will make it more stable but is not necessary. The wheel then fastens with zip ties to the original wheel. Suitable zip ties 4.6x250 mm The zip ties also acts as reinforcements in the spokes of the wheel, thus making it at bit stronger. It is a bit tight to insert the zip ties but dont give up…

The wheel below is wrapped with Jaybird hockey tape for testing. 

I wrapped another wheel with white Wilson overgrip for tennis rackets to get a little bit of a leathery feel to it, although i think black colour is a better option. 

Skillster provides awesome education simulators. Check them out.

Shifter holder assembly: the part that screws on to the joystick should be printed with 100% infill. Reuse the original screws. 

However i recomend this setup, it gives you a little mor leg room.

I also made Joystick replacement parts so you can swap from Elwia to Skillster joysticks on your excavator seats with armrest. Print holder part with 100% infill, same part for left and right side. Screw together with Mounting screw 4.2x13 mm. I also used Socket head screw M5 X 20 mm with matching washers.

And if you want to combine the padels for the Wheel loader to the joystick, I made a part for that to.