Frässchablone / Router Template / Corner Radius Jig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This Router Template can be used for router lifts and also clamped to your workpiece using Microjig clamps (14°).…
- Ocena
- 5 / 5
- Polubienia
- 231
- Pobrania
- 893
- Wydruki
- 8
- Wyświetlenia
- 5135
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This Router Template can be used for router lifts and also clamped to your workpiece using Microjig clamps (14°). Inspired by Snibis_Toolbox thing:4078971, I further worked on improving and extending the design.
All you need is 1x M4 nut and 1x M4x12mm bolt.
Category: DIY
02.02.2023 - Updated main part: now available with reduced cleranace. use this geometry if your printer is well calibrated. In my previous file I had a too large gap, since my printer was not very well set up. The clearance has now been reduced from 0.75 to 0.2mm.
15.03.2024 - added new Inlay for chamfer 30mm, Radius R30, R35 and R40, as well as a blank template to add your own needed chamfer / fillet.