1 / 3
Ender 3 Bullseye Duct - Dual Noctua A4x10 adapter — zdjęcie 1
1 / 3

Ender 3 Bullseye Duct - Dual Noctua A4x10 adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

My stock blower was dying and I was getting a lot of stringing, so I put these noctuas. This is specific for the Ender 3

Ocena
0 / 5
Polubienia
3
Pobrania
22
Wydruki
0
Wyświetlenia
628
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

My stock blower was dying and I was getting a lot of stringing, so I put these noctuas.
This is specific for the Ender 3 Petsfang Bullseye Duct 9.27, which was made for the stock Ender 3 blower.

Uses the screws that came with the Noctua A4x10 fans, they are ~5.5mm OD self tapping screws. They screw from the bottom of the flange

Keep in mind you need to wire the 12V noctuas in a special way to retain PWM function.
https://i.imgur.com/GQElTfP.png
https://www.reddit.com/r/ender3v2/comments/q28kk5/planning_noctua_upgrade_buck_converter_on_part/

Tagi