1 / 2
Wall duct / Brüstungskanal DC plate
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A plate mountable into a Brüstungskanal / Wall duct to provide DC power
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 260
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
For a lab / electronics workspace / makerspace a wallduct is very convenient. You can easily route your cables and place sockets where needed.
I didn't want to have socket and usb/DC wall adapters everywhere so I designed this to provide DC voltage from a central PSU.
Material
- 2x M3 screws (11mm or longer)
- 2x M3 nuts
- 1x round 12V USB insert for cars (sold on eBay or Aliexpress). They are available with 2xUSB Type A or with Type A + Type C
- 6x Banana female socket
- 2x 3D printed clips (model on this page)
- 1x 3D printed cover plate (model on this page)
- cables and connectors for wiring, depending on your needs/setup.
Usage
- print out a cover plate and two clips.
- press the nuts into the openings on the clips
- screw the banana sockets and USB insert into the cover plate
- solder/pin on the cables depending on your setup
- put the screws through the hole in the plate
- screw on the clips with the nuts facing up, don't tighten them completly they still must be able to turn
- turn the clips to point away from the edge, and clip the plate into the wall duct
- tighten the screws, usually the clips will turn automatically and tighten the plate. But if you previously tightenend them too much it might not work