Tailcap magnet Zebralight H602 Headlamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I've created a neodymium magnet holder that fits in Zebralight's Tailcap, if tilcap measures 24.20mm in diameter this…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 273
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I've created a neodymium magnet holder that fits in Zebralight's Tailcap, if tilcap measures 24.20mm in diameter this will work fine!
I did 2 versions, 1 to use with flex materials (the tailcap hole is narrower) 1 to use PLA etc, a little smaller than the tailcap measure.
Contact me if you want to use other magnets measurements; That I can change the design!
Hope you like it!
Remember that drawing uses a 15mmX5mm magnet. https://www.supermagnete.it/dischi-magneti-neodimio/disco-magnetico-diametro-15mm-altezza-5mm-neodimio-n42-nichelato_S-15-05-N
Stop printing and insert magnet inside!
Good printing!
Review for flashlight : http://en.lumenreviews.com/
Print Settings
Printer:
Prusa i3
Rafts:
No
Supports:
No
Resolution:
0.200
Infill:
20%
Notes:
Design optimized for 200 micron resolution.
Category: DIY