SOVOL SV06 PSU case cover for silent 80 mm fan and step-down converter (CHENGLIANG P360W24V)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case cover for the CHENGLIANG P360W24V PSU used in the Sovol SV06, for a 80 mm fan and step-down-converter
- Ocena
- 4,667 / 5
- Polubienia
- 31
- Pobrania
- 215
- Wydruki
- 5
- Wyświetlenia
- 2143
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
After I made the 70 mm and 92 mm Version of the PSU fan case, I got a request for a 80 mm variant from PatrickE which is exactly this one.
I did not test it myself, but PatrickE confirmed that it fits and also provided the pictures, thank you for that!
Attention: the Pictures show the fan on both sides, but PatrickE told me that it will fit only when mounted on the outside! Maybe a flat 80x80x10 could fit, but that you have to try yourself.
There are holes for fusible nuts (M3 with 4.6 mm outer diameter).
Unlike the original case cover, the bottom vents are a bit higher up, so they are not covered on the Sovol SV06.
When wiring, make sure that the cables cannot touch any components that heat up or pull a temperature-resistant protective sleeve over the cable.
There is a small hole in the cover where you can adjust the potentiometer of the step-down-converter. With that you can further reduce the fan noise by slowing it down. Since the fan ist larger and can breath more free than the original fan setup, there should be enough headroom for doing this. Just take care that it starts reliably and blows enough air into the PSU for cooling.
If you like my design, please rate it, leave a like and post a make!