1 / 2
Pi Pico case with room for headers and dupont connectors - blank or voron logo — zdjęcie 1
1 / 2

Pi Pico case with room for headers and dupont connectors - blank or voron logo

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Part of an ADXL accelerometer kit for my Voron, see my other model for the matching kit box. Blank lid also available.

Ocena
5 / 5
Polubienia
12
Pobrania
133
Wydruki
1
Wyświetlenia
672
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Designed and printed in PETG, but it is intentionally a tight fit so you may have to scale it up a bit for ABS.

 

I am not really good with soldering, but fortunately plenty of vendors offer the Raspberry Pi Pico with pre-soldered and even color coded header pins.

 

All of the cases I found here on Printables however were just thick enough for the pico itself and flat soldered wires, so I designed my own case, thick enough for the headers and duponts connectors. I also added a strain relief block to secure the wires with a couple 2mm zip ties before they exit the case.

 

I did mine as part of a calibration set for my voron, following the Nero3d tutorial below, so I also did a matching box to stow the wire and accelerometer on its mounting bracket, so I put a voron logo on them, but I am also iuncluding a blank version of the lid.

 

 Here is the tutorial I have followed:

 

Here is the bracket I used for the Voron 2.4 Afterburner:

https://www.printables.com/model/334193-voron-afterburner-adxl345-mounts

 

And here is my other model with the kit box:

https://www.printables.com/model/376865-resonance-compensation-kit-box-blank-or-voron-logo

 

Tagi