1 / 2
Pi Pico case with room for headers and dupont connectors - blank or voron logo — image 1
1 / 2

Pi Pico case with room for headers and dupont connectors - blank or voron logo

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Part of an ADXL accelerometer kit for my Voron, see my other model for the matching kit box. Blank lid also available.

Rating
5 / 5
Likes
12
Downloads
133
Makes
1
Views
672
Reviews
1

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

Designed and printed in PETG, but it is intentionally a tight fit so you may have to scale it up a bit for ABS.

 

I am not really good with soldering, but fortunately plenty of vendors offer the Raspberry Pi Pico with pre-soldered and even color coded header pins.

 

All of the cases I found here on Printables however were just thick enough for the pico itself and flat soldered wires, so I designed my own case, thick enough for the headers and duponts connectors. I also added a strain relief block to secure the wires with a couple 2mm zip ties before they exit the case.

 

I did mine as part of a calibration set for my voron, following the Nero3d tutorial below, so I also did a matching box to stow the wire and accelerometer on its mounting bracket, so I put a voron logo on them, but I am also iuncluding a blank version of the lid.

 

 Here is the tutorial I have followed:

 

Here is the bracket I used for the Voron 2.4 Afterburner:

https://www.printables.com/model/334193-voron-afterburner-adxl345-mounts

 

And here is my other model with the kit box:

https://www.printables.com/model/376865-resonance-compensation-kit-box-blank-or-voron-logo

 

Tags