Box for Smart Home Bridges
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
One to accommodate them all. Philips Hue, Taco and Bosch Smart Home Controller (including cables)
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 365
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Motivation
All smart home bridges in one place was the goal of this project. At the same time, as little cable clutter as possible.
There are 2 versions for the floor. Depending on the mounting on the wall choose one of these versions
- Tado horizontal -> no matter
- Tado vertical -> choose the variant where the stopper points to the floor
As orientation, on my pictures you can see that I printed the wrong one ;)
Well, at least it was the only version at the time ^^
Hint:
Put the cables on the Bosch BEFORE clicking it on the Plate. It hard to get it off again without breaking the snap-in-pin. Use something flat to push back the pin before lifting the Bosch SHC.
Warning:
The current version fits on the Bambulab X1 Buildplate but NOT on my Prusa MK3S. Cut and glue or let me know if I should try to optimize the size. At the moment I don't know if this project is interesting for a few more people.
Housing for
Philips Hue
Tado
Bosch Smart Home Controller
How to print
Nozzle: 0.4mm
Height: 0.2mm
Supports: helpful but not necessary
What you need
Some M3 Screws and Nuts
For the Hue mount I got inspired by this
https://www.printables.com/model/125408-philips-hue-bridge-rack-mount