1 / 3
Rinser / water dispenser / watering bottle cap for PET-Bottles - Thread with DIN 6063-1 — zdjęcie 1
1 / 3

Rinser / water dispenser / watering bottle cap for PET-Bottles - Thread with DIN 6063-1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This rinser can be printed in place, without any supports. Use a PET bottle of your chosen size and screw on the rinser.

Ocena
4,733 / 5
Polubienia
133
Pobrania
1199
Wydruki
16
Wyświetlenia
3909
Oceny
15

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I've created a rinser that can be applied on every PET bottle with DIN 6063-1 thread (widley used in europe and may be other countries).

How to print?

The model can be printed in place, without any need for support or rims. A smooth print bed is needed, to get the rinser leak-free.

I printed with 2 walls and 20% infill. Using adaptive layer height on a 0,20mm layer preset. I used the smooth function 3 times to get a really good thread and a nice finish on the curves. I also tried without smoothing (you can see the caps on the last photo in the background). This also works without any problems.

How to use the rinser?

Fill a PET bottle with water and screw the shower onto it. To pour, tilt the bottle with the outlet side down so that no water flows out yet. By applying light pressure to the bottle, the amount of water can be dosed. If necessary, set it down in between to refill the bottle with air.

Tagi