1 / 2
X1 Main Board 60mm Fan Duct Upgrade — zdjęcie 1
1 / 2

X1 Main Board 60mm Fan Duct Upgrade

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows the X1 main board cooling fan to be upgraded to a 60mm fan.

Ocena
5 / 5
Polubienia
9
Pobrania
32
Wydruki
1
Wyświetlenia
382
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

While replacing the main board cooling fan in my X1 Carbon, I learned there was enough space to upgrade the fan to a 60x25mm fan. I created these models to achieve this.

There are two models. Both insert over the heat sink on the main board and have a path to direct air over the fin stack.  One has a an additional opening to direct air over the capacitors on the board. I don't think the capacitor cooling is necessary, but if you want to be safe it's not a bad option.

I haven't been able to print this without supports, and suggest you use them. This should be printed with a 0.4mm nozzle. Layer height is up to you, but the higher the resolution you use the better the chamfer I added to aid the insertion onto the heat sink will come out.

I used the Noctua NF-A6x25 5V PWM fan, but any 60mm 5 volt fan should do fine.

Additionally if you don't feel up to creating a new wiring harness you can use this other model I created to relocate the stock fan to above the heatsink.

Tagi