Solid wardrobe with wood
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A solid wardrobe for hallway or garage. I use it for my motorcycle clothes, which is not exactly light.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 205
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I present you a new piece of furniture, which harmonizes perfectly with my already other designs.
The wardrobe has a changeable front panel, I supply you with a few designs, you can create remixes and upload them here, be creative!
I personally use it for my motorcycle clothing, whether I can take off the gloves.
You will need the following:
- Round bar 20x20mm (I took oak and sawed to a length of 25mm, make sure to choose the right .STL, with wood there is usually a +0.5mm tolerance)
- 6x screws (I used SPAX 4x20)
- plastic glue
Assembly:
Places the wall piece (wall_mount_20,45mmX1.STL) with the top side on the table. Take plastic glue and glue the caps (cap_wall_mount_20,45mmX3.STL) into the holes provided. Immediately put the already pre-sawed round rods into the holes (possibly with force).
Now screw in the screws from behind. (Cordless screwdriver very low level, rather too little than too much).
Now do the same with the front cover. At the end you can mount the front panel (I had to fix it with double-sided tape).
Now just mount it on the wall and DONE!
If you like it like it and share it with pleasure.