Hanging Drift Clip - 1/10 Scale RWD Drift
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hanging drift clip for 1/10 rc drift cars
- Ocena
- 5 / 5
- Polubienia
- 123
- Pobrania
- 788
- Wydruki
- 2
- Wyświetlenia
- 3226
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a hanging drift clip for 1/10 RC drift tracks.
Prints in 4 parts.
1 upright - prints flat on the back with the feet pointing up. No supports needed.
1 crossbeam - prints on the side. Supports required under each interlocking tooth. Very minimal. BARELY fits on the MK3S printbed. Literally have to turn it slightly.
1 foot - prints without supports on it's side.
1 hanging drift target - use a LARGE brim inside and outside to keep it attached while it prints standing up.
EDIT: Added a “v2” version of each file.
- The clip itself has more support around the top loop. My son dropped my original…and it broke.
- The crossbeam has been shortened on the backside, and lengthened on the overhang. Less balanced, but more versatile depending on your usage.
- The upright and foot now have pre-created holes for mounting, if you need it.
EDIT #2: I have now also added a “Drift Hit Wall-Mount” alternative for tighter locations. It simply screws straight to the wall.
You can see this drift clip working on my YouTube channel: