SV06 Whole Bed Level Test
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A level test for the whole bed of the SV06. Turn off purge line and skirt.
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 412
- Wydruki
- 2
- Wyświetlenia
- 1405
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- GNU General Public License v2.0
This is a bed level test for the whole bed of the SV06, make sure to disable the purge line in your G-Code Start command and probably turn off the skirt or whatever adhesion type you're using as well. Make sure that the PEI sheet fits well on the bed and is not off. You can disable the purge line by deleting the following lines in the G-Code Start Code:
G1 X10.1 Y200.0 Z0.28 F1500.0 E15 ;Draw the first line
G1 X10.4 Y200.0 Z0.28 F5000.0 ;Move to side a little
G1 X10.4 Y20 Z0.28 F1500.0 E30 ;Draw the second line
Make sure to enable the purge line afterwards again so you have it on your next prints, since it is quite useful. You can edit a M420 S1 line after the G28 ;Home one as well in the next line to load and apply your ABL mesh you saved before for your prints:
G28 ;Home
M420 S1
Print Settings:
Layer Height: 0.2mm
Print Speed: 50mm/s