Wheel Mode Gear for Mario Kart XL RC Racer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the gear to switch from normal to anti-gravity mode with the Mario Kart XL RC Racer
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 256
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
I printed two of these in PLA, which is all I have handy. My son gave the kart a spin and we both played with the mode-switch a bit with no issue. I decided that if the gears get stripped again it's no big deal since I can reprint them immediately, now.
No special settings. Higher resolution may increase durability, but I printed at .14 with no issue. It's a small print, so it will end up solid.
Printed with the teeth up, default supports at 80 degree angle worked well. Could probably print with teeth down and no supports, but my printer doesn't like to print without a raft, so I would have to clean up the teeth.