DJI Phantom 4 Battery Cage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is designed to hold a Phantom 4 battery on a different drone.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 77
- Wydruki
- 0
- Wyświetlenia
- 727
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is designed to hold a Phantom 4 battery on a different drone. The mounts are designed to fit 10mm rails at roughly 60mm apart. This is designed to take a DJI P4 power board that sits on lugs at the rear. The lugs can be then melted over to retain the board. The mounting of this board is not yet finalised although it works. The pins may be a fraction off, I just shaved off the edges to fit. WORK IN PROGRESS.
I printed this end-on ie with the lugs pointing down and using support.
Print instructions
Category: R/C Vehicles Summary
This is designed to hold a Phantom 4 battery on a different drone. The mounts are designed to fit 10mm rails at roughly 60mm apart. This is designed to take a DJI P4 power board that sits on lugs at the rear. The lugs can be then melted over to retain the board. The mounting of this board is not yet finalised although it works. The pins may be a fraction off, I just shaved off the edges to fit. WORK IN PROGRESS.
I printed this end-on ie with the lugs pointing down and using support.
Print Settings
Printer Brand: Prusa
Printer: i3 MK2S
Rafts: Yes
Supports: Yes
Resolution: .15
Infill: 100%