Dryer or fan exhaust vent flap / louver
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement flap / louver for an outdoor louvered exhaust hood. Flap is 122 mm wide by ~33 mm high, 2.8 mm thick.
- Ocena
- 5 / 5
- Polubienia
- 35
- Pobrania
- 235
- Wydruki
- 1
- Wyświetlenia
- 2867
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A tab broke from from one of the flaps on the exhaust hood for my dryer. Although I found several other models on Printables, none quite fit my application.
This replacement louver is designed to be 122 mm wide by ~33 mm high, 2.8 thick. Because the purpose of these louvers is to open when exhaust airflow passes, I thought is was important to keep the same general weight as the original part. The original louver was ~5.7 g and this model will print to a similar weight in PETG using the default 0.20 mm QUALITY preset in PrusaSlicer.
The external facing side is designed to be printed face down as the first layer. Using PETG and the textured sheet gives this a reasonable finish to match the faux wood grain on the original louver. This flat face is a slight tradeoff to the original louver which has a slight arc to it, however the flat face does not seem to impact function
Since this is intended for outdoor use, PETG or ABS is recommended. The part also needs a bit of flex while fitting the tabs so PLA is not advised. Part could be painted to match using appropriate primer and paint for plastic.