1 / 2
Fanmount heatsink 5015 SovolSV06 heatcreep fix
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
5015 Fanmount for the heatsink of a SovolSV06
- Ocena
- 5 / 5
- Polubienia
- 42
- Pobrania
- 171
- Wydruki
- 8
- Wyświetlenia
- 1729
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 8) (Komentarze: 17)Remiksy (1)Kolekcje (65)Powiązane
The Sovol SV06 faces a challenge in which prints with frequent retractions tend to fail due to clogged nozzles. This issue is caused by heat creep, as the heat dissipation is inadequate.
To resolve this problem, the following steps are recommended:
- Replace the thermal paste on the heatbrake. The original factory application is faulty.
- Upgrade the fan. The current fan installed is of poor quality. If you would like to see if a high-quality replacement fan can fix the clogging, consider replacing the existing fan with a new one first. As an alternative, the holder shown can be used to mount a 5015 fan, which is significantly louder but will ensure the issue is resolved.
The following items are required:
- 1x 5015 fan with 24V DC (It is recommended to purchase two and replace the part cooling fan as well)
- 2x M3 screws, at least 18mm in length.
In the absence of connectors, the cables from the old and new fans were simply soldered together.
The design may not be perfect and far from optimized, but it works and I have no desire to invest more time into it.