1 / 9
Bambu Lab - Purge /Flush/Poop bucket for X1 and P1 Series - MAGNETIC Add On — zdjęcie 1
1 / 9

Bambu Lab - Purge /Flush/Poop bucket for X1 and P1 Series - MAGNETIC Add On

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

If you already printed a bucket you can use this to make it magnetic instead of printing a new one.

Ocena
0 / 5
Polubienia
38
Pobrania
116
Wydruki
1
Wyświetlenia
4393
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

My Bambu X1C vibrates quite a lot which means sometimes the bucket is being pushed away. When that happens I find filament everywhere on the table. That's the reason why I made this Remix.

Seeing that I already had a functioning bucket I didn't want to print another one, so I made this Add On / upgrade to add magnets to existing ones.

The files have been made with Fusion360.

 

----------------------------------------------------------------------------------------------------------------

If you want to help me out a bit and see some stuff I made, work in progress, or models before they will be here consider liking and following my Facebook page, thank you very much - it means a lot to me! :)
If I link something on Amazon, those are affiliate links. Doesn't cost you anything but helps me grab a cup of coffee from time to time - thank you! :)

----------------------------------------------------------------------------------------------------------------

 

 

  • Print with:

    • PLA

    • 3 wall loops

    • 15% infill

    • no supports are needed

    • no brim needed

    • BambuLab_Bucket_AddOn_Short

      • The nut holes should be facing upwards

    • BambuLab_Bucket_AddOn_Long

      • The nut holes should be facing towards the bed

 

  • Additional stuff:

    • Just glue in your magnets into the cutouts.

      • Different magnet sizes are available. If your's is missing just comment.

    • For assembly refer to the pictures attached.

      • BambuLab_Bucket_AddOn_Short

        • Use the short part as a ruler outside to make drilling easier

        • The little overhang is for easy of drilling

      • BambuLab_Bucket_AddOn_Long

        • Place on even ground

        • The face with the cutouts should be flush with the face of the bucket

        • Drill the middle hole first

        • Secure it with the screw

        • Drill the two outer holes

 

  • Parts:

    • BambuLab_Bucket_AddOn_Short_d%x%mm

      • as provided

    • BambuLab_Bucket_AddOn_Long_d%x%mm

      • as provided

    • M3x12mm Flathead or count screw

      • 5 pieces

      • 12mm long

    • M3 nut

      • 5 pieces

 

  • Magnets:

    • I have a bunch of those d5x1mm magnets. Depending on the size of the hole i just put the necessary amount in, that ways the magnets are usable more flexible.

    • Here are some d5x5 magnets.

 

  • Updates:

    • none so far

 

----------------------------------------------------------------------------------------------------------------

I'm looking forward to your comments and makes. :)

Tagi