car phone/tablet holder for Skoda Octavia 2 Facelift 2010
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Phone and tablet holder 2 in 1 for Skoda Octavia 2 Facelift 2010 dashboard compartment, the holder has two arms that…
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 115
- Wydruki
- 0
- Wyświetlenia
- 3588
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Phone and tablet holder 2 in 1 for Skoda Octavia 2 Facelift 2010 dashboard compartment, the holder has two arms that lock around the compartment door hinges, you can easily install and take it off with one hand motion.
I forgot what exactly the tablet and phone was.
Tablet was a Nexus, the space is 202mm wide, the phone slot is 160mm wide.
Besides printed parts you'll need some glue, a paper clip and two M3 screws and bolts.
If you find this useful or entertaining enough, tips are welcome. :)
Gallery of pictures and video: https://imgur.com/gallery/lxobF6E
Print Settings
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
Yes
Resolution:
0.1
Infill:
20%
Filament: DevilsDesign PETG Black and Orange
Notes:
Print as is.
5 perimeters for hookerA\_V2, no exceptions.You'll find all the individual pieces and the whole thing assembled for clarity.
You'll need some glue, a paper clip, two M3 screws and bolts, x-acto knife/box cutter, file(s) and pliers (to cut the paper clip).
You'll need a paper clip for the small joints, I cut bits off of one and tapped them into the holes and put a small drop of glue. make sure the glue doesn't drip inside and lock the joint. The only purpose of the glue is to hold the pin in, it doesn't need to be good or to penetrate.
holderA_V2 needs supports for the mid section, the piece is raised there to avoid a rubber dot on the dashboard and other stuff you may have in the compartment.
holderB_V2 is simple and straightforward. Glue this piece to holderA_V2 once both pieces are processed.
hookerA_V2 needs supports for the joints, print with a 5mm brim, it likes to raise off the bed where it's near the edge of the print bed. You will also need to file the slot for
hookerB_V2 if it gets covered up. I had to but I printed it hot for extra endurance.
hookerB_V2 needs supports and brim, will take some cleaning up. I recommend printing this with hookerC_V2 x2 to minimize brim waste.
hookerC_V2 needs supports and brim, will need light filing for the joints.
hookerD_V2 needs supports and brim, unless you want to print it another way, your choice.
If you find this useful or entertaining enough, tips are welcome. :)
Category: Automotive