Switch Lite Grip/Cover

After lots of use of my Case the case started to fail at the top "clip". so I started making a new one!

this design is more modular and allows one to print a case in multiple colors easily. I hade 3 sets of grips and main body cases with different designs. for the middle part, I put the following designs to the back The switch logo, Zelda Tri-force, Pokemon Pokeball, Animal Crossing leaf, Smash Bros, and a regular back.

You can also find the Fuson 360 file for this so you can make your own grips or add your own designs to it!

Print instructions

Category: Accessories Summary

After lots of use of my Case the case started to fail at the top "clip". so I started making a new one!

this design is more modular and allows one to print a case in multiple colors easily. I hade 3 sets of grips and main body cases with different designs. for the middle part, I put the following designs to the back The switch logo, Zelda Tri-force, Pokemon Pokeball, Animal Crossing leaf, Smash Bros, and a regular back.

You can also find the Fuson 360 file for this so you can make your own grips or add your own designs to it!

Print Settings

Printer Brand: Prusa

Printer: i3 MK3 MMU 2

Rafts: No

Supports: Yes

Resolution: .1-.3

Infill: low

Filament: vareus PLA Red/Black/blue(tortoises) Post-Printing

sanding / filling required.

when you're done other than removing leftover material, you will need to remove a bit from the slots on both the body and grips (mostly the body). this would allow an easy fit. to little and you may need a hammer to tap it in (carefully).