1 / 9
Simple Chopstick Rests (Ultra low filament cost <2g each)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here are some fairly simple chopstick rests I put together for the 'Chopstick Holders' contest. I hope you like them!
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 42
- Wydruki
- 1
- Wyświetlenia
- 225
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (9)Wydruki i komentarze (Wydruki: 1) (Komentarze: 2)Remiksy (0)Kolekcje (11)Powiązane
Here are some fairly simple chopstick rests I put together for the 'Chopstick Holders' contest. Each of the six models should print with less than 2g of filament using normal print settings.
- All of the models are already oriented in their intended printing position, no support required.
- Printing in .15mm layer height or higher resolution will help the curved top surfaces on the horizontal models (#2, #4, #6) print more smoothly. The vertically oriented models (#1, #3, #5) can be printed in .2mm layer height without any huge visual difference.
- The thin walled models (1#, #3, #5) may require you add brims or brim ears since they have a fairly small surface area on the bed for adhesion.
Source Fusion360 files (.f3d) included below for easy remixing.
Printed in Fillamentum PLA Extrafill Vertigo Jade (it's quite stunning and easy to print, the photos don't really do it justice)
I hope you like them!