1 / 6
Flying Saucer Fidget Spinner — zdjęcie 1
1 / 6

Flying Saucer Fidget Spinner

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Flying saucer fidget spinner.

Ocena
0 / 5
Polubienia
14
Pobrania
53
Wydruki
0
Wyświetlenia
555
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I was inspired by MechanicalNinjeer's UFO Fidget Spinner design (https://www.thingiverse.com/thing:5763899).  But, I didn't have a ‘standard’ bearing. Since I only had a small bearing, I remade the design to fit hardware that I had. I also wanted a flat UFO that fit neatly in a front pocket. This design has a total print time less than 30 minutes!

Bearing: 693ZZ (ID 3mm, OD 8mm, Thickness 4mm) https://www.amazon.com/s?k=693zz+mini+ball+bearings&i=industrial&sprefix=693ZZ%2Cindustrial%2C125&ref=nb_sb_ss_fb_1_5

I added a large washer (ID 14.5mm, OD 35mm, Thickness 2.1mm) for extra weight. There is one pause built into the saucer gcode so you place the washer inside the print. Hit “resume” and the washer is neatly sealed inside the saucer body.

I used glow-in-the dark PLA for the cockpit dome and bottom piece.

PRINT INSTRUCTIONS: Print all three parts 1x each. The saucer gcode has a pause for you to set the washer in place--select resume to continue. The bearing slips into place. Feed the bottom piece through the bearing and glue into the cockpit

Tagi