3030 400mm led light holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I created a 400mm long led light holder for 3030 extrusions to use for my ratrig v-core-3 500.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 65
- Wydruki
- 0
- Wyświetlenia
- 669
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I was looking for a way to mount leds to light up my build volume, so here's a led holder with M5 bolt-holes and a diffuser which connects to the led holder with 2,5mm strips.
The diffuser should be printed in clear PETG with 100% rectilinear infill, while the holder should be printed in black. I used ASA for this.
Since I made these for my ratrig v-core-3 500, here is my exert from printer.cfg in the user overrides section:
[output_pin LED_pin]
pin: PB10
pwm: True
value: 0
cycle_time: 0.010PB10 on the BTT Octopus is a 24V heater-connection, seeing as I have 24V led-strips, YMMV.
Here's a picture of an old print under the led lights:
(https://www.printables.com/model/2216-alien-xenomorph-full-figure-25-cm)