Sovol SV06 Gantry WS2812B LED Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A gantry mount for a single WS2812B LED, with a cable tunnel to the Filament Runout Sensor Pin
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 1568
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Gantry mount that adds a WS2812B LED to the gantry of the Sovol SV06 using the screws used to mount the hotend to the gantry.
Printing
Layer height should be fine (≤ 0.2mm) to properly trap the LED, but otherwise prints fine with a 0.6mm nozzle. Black PLA hides the mount quite well.
Assembly
Glue the LED onto the cutout and feed the wires through the tunnel. Remove the screws (careful, they are 2 of 3 screws holding the hotend plate), add the LED mount and if possible, replace with longer screws (M3x10 countersunk worked for me, the hole with the fitting should be ~11mm deep)
Wiring
The JST GH 1.25mm connector on that side should be wired as follows (top-to-bottom): 5V, Ground, PA4 (no guarantees!).
Example Klipper Configuration:
[neopixel hotend_neopixel]
pin: PA4
chain_count: 1
color_order: GRB
I've added a tunnel version if you'd like to hide the cable to the pin even more, I'm happy with the simple version (full disclosure: I haven't tried the tunnel version).