Sovol SV06 Gantry WS2812B LED Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A gantry mount for a single WS2812B LED, with a cable tunnel to the Filament Runout Sensor Pin
- Rating
- 0 / 5
- Likes
- 22
- Downloads
- 70
- Makes
- 0
- Views
- 1,571
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Gantry mount that adds a WS2812B LED to the gantry of the Sovol SV06 using the screws used to mount the hotend to the gantry.
Printing
Layer height should be fine (≤ 0.2mm) to properly trap the LED, but otherwise prints fine with a 0.6mm nozzle. Black PLA hides the mount quite well.
Assembly
Glue the LED onto the cutout and feed the wires through the tunnel. Remove the screws (careful, they are 2 of 3 screws holding the hotend plate), add the LED mount and if possible, replace with longer screws (M3x10 countersunk worked for me, the hole with the fitting should be ~11mm deep)
Wiring
The JST GH 1.25mm connector on that side should be wired as follows (top-to-bottom): 5V, Ground, PA4 (no guarantees!).
Example Klipper Configuration:
[neopixel hotend_neopixel]
pin: PA4
chain_count: 1
color_order: GRB
I've added a tunnel version if you'd like to hide the cable to the pin even more, I'm happy with the simple version (full disclosure: I haven't tried the tunnel version).