Magnetic tweezer holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tiny part designed to have magnet glued in, and hold tweezers strong enough not to fall while loose enough to pull off.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 204
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
This tiny holder has the slightest taper to its inner channel; which, when a suitable magnet is superglued in place, allows it securely hold onto a pair of metal tweezers upright without dropping. At the same time, it leaves nearly all of the tweezers exposed, allowing for good air drying and easy grabbing.
This is designed to fit the 2x8mm disk magnets from Harbor Freight.
Only 10 minutes to print 2 of these bad boys at 100% infill!
NO SUPPORTS REQUIRED. Even though the underside is technically an overhang, the piece is too small to matter.