Clipon 40mm fan mount for Kossel Mini 2020
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This fan mount just clips on the inside of the lower frame of a 2020 aluminium Kossel Mini (in my case a Folger Tech…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 337
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This fan mount just clips on the inside of the lower frame of a 2020 aluminium Kossel Mini (in my case a Folger Tech kit). I use three of these clips to have some air movement over the tower stepper motors in order to keep them cool.
Each fan is mounted on the rail about 0.5-1 inch away from the stepper motor and blowing over the side and rear. This keeps the stepper motors nice and cool, whereas before I would have failed prints due to overheating motors.
To me this is an essential upgrade for any (FolgerTech) kossel!
Print instructions
Category: 3D Printer Parts Summary
This fan mount just clips on the inside of the lower frame of a 2020 aluminium Kossel Mini (in my case a Folger Tech kit). I use three of these clips to have some air movement over the tower stepper motors in order to keep them cool.
Each fan is mounted on the rail about 0.5-1 inch away from the stepper motor and blowing over the side and rear. This keeps the stepper motors nice and cool, whereas before I would have failed prints due to overheating motors.
To me this is an essential upgrade for any (FolgerTech) kossel!
Instructions
Mount fan with 12mm M3 bolts and nuts.