AX24 - Shortened Aftermarket Servo Mount - Remixed

AX24 - Shortened Aftermarket Servo Mount - Remix

Shortened Aftermarket Servo Mounts for the Axial AX24. 
A couple of mm was trimmed off of the front of the original, moving the servo closer to the center of the vehicle, which seemed to better align the steering drag with the steering link and the servo horn.
 

Including Three Versions:

• Version 1: Stock Servo Angle with Servo Mounting Holes - Shortened
  This was modified from the original to allow for aftermarket servo installation at the Stock servo angle. The front of the mount was also trimmed/shortened to better align the steering drag link.
   
• Version 2: Modified Servo Angle (Tilt) with Servo Mounting Holes - Shortened
  Leaning the servo back a couple of degrees, allowing for greater clearance around stock body mounts and a bit better articulation in the front end.
  This was modified from the original. The front of the mount was trimmed/shortened to better align the steering drag link. and also includes the mounting screw holes needed to fasten the servo.
   
• Version 3: Original Model with Servo Mounting Holes
  This was modified from the original version to include servo mounting holes.

I used an AGFRC 9g servos in my installation. (https://www.amazon.com/dp/B07V5XR55Q)
EMax servos, will also align in the mounting holes.

Parts were printed in PRUSA Orange - PETG

The original model is not my creation. Thank you to the creator. I have only trimmed the front mount and included servo mounting holes also creating a 2nd version that will allow for a Stock servo angle.
THANK YOU to the original creator!