11 modeli
To manually adjust steering trim of the AX24 Rock Crawler, since the stock controller does not allow trim adjustments of the rear steering.
Wydruk około 0,06 €–0,07 € nettoWstępna wycena jednego wariantu
Driveshaft for 1/24 scale crawler axial SCX24 and Probably AX24. First pass so still a little rough but practical. Designed this so I could flip my motor/transmission around for more weight forward. Needed custom driveshaft lengths. I…
AX24 XC-1 52mm High Clearance Lower Suspension Links A set of stock length High Clearance Lower Suspension Links for the AX24 XC-1. I wanted a set of color suspension links to match the Orange body of the AX24 itself. Printed in Prusa…
Axial SCX24 and AX24 compatible stock width Steering Link with included Drag Link I was wanting a color matched Steering and Drag link for my Orange AX24, a few moments later I had these printing for my enjoyment, in the color of my…
A simple set of preload spacers that will fit the stock Shocks on your SCX24 and AX24 rock crawlers. These can be used to adjust the amount preload on your shocks, therefore adjusting ride height of your crawler itself. When used in the…
A set of stock length upper suspension links for the AX24. I wanted a set of color upper suspension links to match the Orange body of the AX24 itself. Printed in Prusa Orange PETG
SCX24 / AX24 Steering Drag Links When replacing the stock servo's in an AX24 or adding rear steering to an SCX24, you may need differing length Steering Drag Links for better rear alignment. Shortened Links 20mm & 20.5mm Stock Length 21mm…
AX24 - Shortened Aftermarket Servo Mount - Remix Shortened Aftermarket Servo Mounts for the Axial AX24. A couple of mm was trimmed off of the front of the original, moving the servo closer to the center of the vehicle, which seemed to…
Weighted Wheels for Axial AX24 (1/24 AX24 XC-1 4WS CRAWLER) (This may work on SCX24s and similar sized crawlers but I have only tested it on an AX24) The weight added comes from Washers slid onto the part "Wheel Hub Main" before gluing on…
created mounts to get deadbolt body on the ax24 gave it enough lift that it wouldn't rub
Hardbody for an axial AX24, very much still a work in progress. Requires printing and post processing, sanding down some corners where you like. Since this is a work in progress I will not be providing much assembly and post processing…
