RatRig VCore 3.1 integrated rear arm Z Chain Mount (10x11 dragchain mod)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Yet another Z Chain Mod, this time directly connected to the rear Z bed arm. Mod for 10x11mm dragchain.
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 103
- Wydruki
- 0
- Wyświetlenia
- 821
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Mod for 10x11 dragchain with openings (https://www.aliexpress.com/item/32214281467.html).
Original mount didn't fit on my Vcore3.1 anyway (insufficient clearance when Z=0), I had to mod it a little bit more than just adjusting holes for dragchain.
It is mod, but especially in case of upper part, I was unable to mod it from STL so I redrawed it from scratch (that's why it differs a bit more than it has to be). Plus added protection wall for wires (just in case).
BOM:
6x Heat inserts (M3x5x4)
6x M3 countersink screws
2x M6 T-nuts for 3030 ("V-core3 extra parts bag" will have it)
2x M6x12 counterbore screws (same as with T-nuts)
10x11 dragchain